Controller Issue - won't turn back on.

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
scubanimal
Posts: 35
Joined: Wed Mar 06, 2013 2:05 pm

Controller Issue - won't turn back on.

Post by scubanimal »

I ran a long job last night, and due to that silly USB issue with Win10, I just off the controller to re-establish the connection to my PC. Only the controller would not turn on. I checked the fuse, it looked fine, but changed it out anyway. It still will not turn on. I'm getting power to the panel. So I'm at a loss as to why it stopped working. I'm wondering if it just got hot, and if that is the case will it reset.

Anyone had something similar, and what was the resolution?

Thank you,
Ian

Barry Anderson
Posts: 52
Joined: Sun Dec 21, 2014 9:55 pm

Re: Controller Issue - won't turn back on.

Post by Barry Anderson »

This has happened to me. I called NWA and one of the tech guys talked me through some diagnotics. Still had to send it in. Turns out the control board had to be replaced. They did have a fast turnaround. They got it one day and shipped it back out the next.

Barry
Barry Anderson
Anderson Custom Woodwork, Inc.

scubanimal
Posts: 35
Joined: Wed Mar 06, 2013 2:05 pm

Re: Controller Issue - won't turn back on.

Post by scubanimal »

Thanks Barry,
Same for me, shipped it back this morning.

Post Reply