musclechuck

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

musclechuck

Postby gpeck » Sat Sep 09, 2017 6:17 pm

Has anyone used a musclechuck on a bosch 1617EVS. The chuck that is on the router is not holding the bit
like it should anymore.
gpeck
 
Posts: 164
Joined: Fri Sep 06, 2013 1:35 pm

Re: musclechuck

Postby sk8nmike » Mon Sep 11, 2017 5:43 am

Check for debris in the chuck around the tightening screw and slot. I had one of these years ago and had unacceptable results from it. I switch to a collet system from PresiceBits, better hold, less runout and I get a better variety of bit shank sizes..

http://www.precisebits.com/gateways/Col ... m#paneTwo1
sk8nmike
 
Posts: 383
Joined: Thu Dec 01, 2011 7:35 am
Location: Carrollton, Tx


Return to CNC Shark Pro Plus HD

Who is online

Users browsing this forum: No registered users and 1 guest