I am about to use cypress wood for the first time to make a small sign for a customer. Will be using a 90* v-bit. I would welcome any suggestions/help/advice from those of you with experience working with cypress.
Thank you.
Barry Anderson
Cypress Wood
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 52
- Joined: Sun Dec 21, 2014 9:55 pm
Cypress Wood
Barry Anderson
Anderson Custom Woodwork, Inc.
Anderson Custom Woodwork, Inc.
-
- Posts: 52
- Joined: Sun Dec 21, 2014 9:55 pm
Re: Cypress Wood
Finally got to cut the cypress wood sign. Used a new 90* bit, 100 ipm feed rate, 17,000 rpm. Very pleased with the result. Hope this information helps someone else.
Barry Anderson
Barry Anderson
Barry Anderson
Anderson Custom Woodwork, Inc.
Anderson Custom Woodwork, Inc.