Virtual Zero
Posted: Tue Nov 28, 2017 7:59 am
I have been using Virtual Zero and touch plate for nearly two (2) years now with some minor problems/occurrences -- all of a sudden out of the blue it has decided to act up.
Specifically after setting z-zero - click run Virtual Setup the spindle/router instead of moving on the x and y to the first of five positions the Z-axis it races skyward. I have checked all connections which are good. I have rebooted both the control box (power Off/0n). I have completely shut everything down and restarted. All to no avail --- virtual zero Z-axis still races skyward each and every time.
Has anyone out there with Virtual Zero and Touch plate come across this problem/dilemma/mystery? If so, what was done to solve the problem/dilemma/mystery?
I have had some strange occurrences over the last two years with Virtual Zero & Touch plate and have been able to solve each but this problem/dilemma/mystery has me stumped!
Sharkcutup
Specifically after setting z-zero - click run Virtual Setup the spindle/router instead of moving on the x and y to the first of five positions the Z-axis it races skyward. I have checked all connections which are good. I have rebooted both the control box (power Off/0n). I have completely shut everything down and restarted. All to no avail --- virtual zero Z-axis still races skyward each and every time.
Has anyone out there with Virtual Zero and Touch plate come across this problem/dilemma/mystery? If so, what was done to solve the problem/dilemma/mystery?
I have had some strange occurrences over the last two years with Virtual Zero & Touch plate and have been able to solve each but this problem/dilemma/mystery has me stumped!
Sharkcutup