Bits for carving in foamed pvc(palight)

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

Bits for carving in foamed pvc(palight)

Postby lockeb » Thu Dec 07, 2017 7:24 am

I want to experiment with some 1/2 inch foamed pvc. I would welcome any suggestions on bits to use 0 flits?,1,2? V bits?
lockeb
 
Posts: 36
Joined: Thu Nov 15, 2012 10:35 am

Re: Bits for carving in foamed pvc(palight)

Postby sk8nmike » Wed Dec 13, 2017 8:40 am

I carve Pink Foam insulation board all the time using regular bits with good results, just be sure they are sharp. Four flutes should give you a better finish as they take of less material per cut then 2 fluted bits at the same feed rate.
sk8nmike
 
Posts: 378
Joined: Thu Dec 01, 2011 7:35 am
Location: Carrollton, Tx


Return to CNC Shark Pro Plus HD

Who is online

Users browsing this forum: No registered users and 1 guest