Page 1 of 1

Bits for carving in foamed pvc(palight)

Posted: Thu Dec 07, 2017 7:24 am
by lockeb
I want to experiment with some 1/2 inch foamed pvc. I would welcome any suggestions on bits to use 0 flits?,1,2? V bits?

Re: Bits for carving in foamed pvc(palight)

Posted: Wed Dec 13, 2017 8:40 am
by sk8nmike
I carve Pink Foam insulation board all the time using regular bits with good results, just be sure they are sharp. Four flutes should give you a better finish as they take of less material per cut then 2 fluted bits at the same feed rate.