Registering or transfering ownership
Posted: Fri Dec 15, 2017 5:16 pm
Hi
I am going to be gifting my nephew with my CNC SHark HD Pro for Christmas.
I was wondering what I would need to do to transfer the control panel software over to him. He will be putting this onto his own laptop/computer to use in his workshop.
It is the old version 1.5 control panel.
I also need to know what to do regarding the touch-plate. I have located the box that it came in but not the piece of paper with the code number on it. I did notice there is a 6 digit code on the cord itself (xxx-xxx) is this perhaps the code number he will need to register this piece of hardware with ?
Thank you for your help
DougE
I am going to be gifting my nephew with my CNC SHark HD Pro for Christmas.
I was wondering what I would need to do to transfer the control panel software over to him. He will be putting this onto his own laptop/computer to use in his workshop.
It is the old version 1.5 control panel.
I also need to know what to do regarding the touch-plate. I have located the box that it came in but not the piece of paper with the code number on it. I did notice there is a 6 digit code on the cord itself (xxx-xxx) is this perhaps the code number he will need to register this piece of hardware with ?
Thank you for your help
DougE