Shark Pro Plus HD Maintenance
Posted: Wed Apr 11, 2018 8:10 pm
After just a little over two years and only the Good Lord knows how many CNC Projects have been run on my machine It was time to re-surface the MDF spoilboard!!!
Here is what the spoilboard looked like after the CNC machine re-surfaced the spoilboard. Removed .1" from spoilboard surface using a 1.25" diameter mortising router bit. I then cleaned everything to get any MDF dust off of CNC mechanics and gave the it a good lube!!!
Note: not sure why the photos are upside down here but they do come up correctly when clicked on --- strange!!!!
Sharkcutup
Let Those Chips Fly!!!
So I setup my machine along with a dust boot (which I do not normally use cause MDF creates a lot of fine dust). Then created a .crv file in VCarve to re-surface the spoilboard. Here is what the spoilboard looked like after the CNC machine re-surfaced the spoilboard. Removed .1" from spoilboard surface using a 1.25" diameter mortising router bit. I then cleaned everything to get any MDF dust off of CNC mechanics and gave the it a good lube!!!
Note: not sure why the photos are upside down here but they do come up correctly when clicked on --- strange!!!!
Sharkcutup
Let Those Chips Fly!!!