Use of the Dust Boot

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Use of the Dust Boot

Post by sharkcutup »

Two years ago when I first setup my CNC Shark machine I had decided not to use my dust boot in which I had originally purchased and intended to use. It was not until I decided to re-surface my MDF Spoilboard that I attempted to installed and use my Dust Boot. I can remember when I had cut the keyhole slots in the Spoilboard how much dust was kicked up from that MDF material. It is just that I
have always enjoyed monitoring/watching the CNC machine perform its tasks and just followed along with vacuum from time to time for ongoing cleanup.

Since I have discovered how well the dust boot functions after re-surfacing the spoilboard I have decided to leave it installed and try to work with it. Just have to adjust the end clamp (at +Y) on the project boards for proper clearance. The dust boot worked very efficiently keeping not only the dust from being airborne but it kept alot of chips/shavings from getting thrown everywhere. The Dust Boot for the most part keeps chips/shavings confined to the size of the boot and what little did not get sucked up by the vacuum remained on the project board/CNC table.

I have to admit too that after two years using the CNC Shark I am much more comfortable as to the "Gotchas" that may or may not occur so I do not need to monitor the machines progress as much now!

WOW! Less frequent workshop vacuuming!!!

Sharkcutup
Let Those Chips Fly!!!
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

User avatar
bill z
Posts: 342
Joined: Fri Sep 25, 2015 9:09 am
Location: Spring, Texas USA

Re: Use of the Dust Boot

Post by bill z »

I know the feeling Sharkcutup.

However, I still love to watch or maybe show someone how it is cutting. To live some in both worlds, I have a boot where the top is made of clear plastic and have it at such an angle that I can easily see the bit cutting into the material that I'm cutting. This way, I have a nearly dust free environment and can see the cuts also.

I'm tempted to modify a USB camera and insert it in the boot and then put the picture on the computer screen. Thes USB cameras are so cheap now a days that ti shouldn't cost very much at all.

Saying all of this, I bet someone has already done it. Maybe they will share.

Post Reply