Thanks!!
Dash
Error Message
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Error Message
Guys and Gals.......I know I have asked before... But because of Karen, I know how to use a snipping tool!!!! Yay!! Ahem......And how do I fix it. I gotta get these cut out.....
Thanks!!
Dash
Thanks!!
Dash
Re: Error Message
Dash.
The area into which the tool needs to cut is either exactly the same as the diameter of the tool or smaller. You can make the slots .0001" wider. Or, you can re-define the diameter of the tool as a little bit smaller (.2499)
At least this is how I get around the problem.
Or, I just use a smaller diameter bit, and re-calculate the toolpath.
Bob
The area into which the tool needs to cut is either exactly the same as the diameter of the tool or smaller. You can make the slots .0001" wider. Or, you can re-define the diameter of the tool as a little bit smaller (.2499)
At least this is how I get around the problem.
Or, I just use a smaller diameter bit, and re-calculate the toolpath.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Error Message
Morning... Making a simple profile toolpath. Changed bit diameter...Nothing....Very frustrating...
Re: Error Message
This issue was solved over on the Vectric site...http://forum.vectric.com/viewtopic.php? ... ge#p148474
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Error Message
Yep - that'll do it... the old overlapping vector thing.
Re: Error Message
OH MY!!!!
Ya'll I am soooo sorry. I should have checked this site and responded. That was rude and I apologize. You all have always been so responsive and I appreciate it. I looked back at a post I made a couple months ago and still could not figure out what I was doing...I finally saw it.....ANd I think it was the problem we all were working on then. You all didn't have the problem with it but for the life of me, I couldn't see it.
Another lesson learned and the help is very much appreciated.
My apologies, again.
Sincerely,
Dash
Ya'll I am soooo sorry. I should have checked this site and responded. That was rude and I apologize. You all have always been so responsive and I appreciate it. I looked back at a post I made a couple months ago and still could not figure out what I was doing...I finally saw it.....ANd I think it was the problem we all were working on then. You all didn't have the problem with it but for the life of me, I couldn't see it.
Another lesson learned and the help is very much appreciated.
My apologies, again.
Sincerely,
Dash