Where can I find info on importing 3d carving to V carve? I know I have read this on the forum, but I cannot find it...
Thanks to all....
Dash
3d Carving imported to V Carve
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: 3d Carving imported to V Carve
I'm not sure that you can import a 3d model, only a .3cv file.
http://www.vectric.com/WebSite/Vectric/ ... Aspire.pdf
http://www.vectric.com/WebSite/Vectric/ ... Aspire.pdf
Re: 3d Carving imported to V Carve
Hi Dash,
Try these out for starters:
http://www.cncsharktalk.com/viewtopic.php?f=10&t=387
http://www.cncsharktalk.com/viewtopic.php?f=10&t=823
http://www.cncsharktalk.com/viewtopic.php?f=8&t=382
If you have specific questions - by all means ask!
Try these out for starters:
http://www.cncsharktalk.com/viewtopic.php?f=10&t=387
http://www.cncsharktalk.com/viewtopic.php?f=10&t=823
http://www.cncsharktalk.com/viewtopic.php?f=8&t=382
If you have specific questions - by all means ask!
Re: 3d Carving imported to V Carve
Holy cow, Dude!!
I knew the topic was discussed but, Jeb....Wow! You are good. One link is all I need: everything is explained. Thanks so much. For me and everyone else!!
Sk8tn...I knew I asked the wrong way...LOL.. Some of us in West Texas takes a little while longer...LOL..
Thanks to all!!
Dash
I knew the topic was discussed but, Jeb....Wow! You are good. One link is all I need: everything is explained. Thanks so much. For me and everyone else!!
Sk8tn...I knew I asked the wrong way...LOL.. Some of us in West Texas takes a little while longer...LOL..
Thanks to all!!
Dash
Re: 3d Carving imported to V Carve
Dash wrote:Sk8tn...I knew I asked the wrong way...LOL.. Some of us in West Texas takes a little while longer...LOL..
Thanks to all!!
Dash
My bad, I work across several platforms where 3D refers to CAD files and sometimes forget most of the people here only work one where 3D = Vectric.
Mike