bed sag

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
Jim N
Posts: 104
Joined: Fri Jul 30, 2010 3:45 pm

bed sag

Post by Jim N »

I see there are some of problems with bed sag, etc.
Here is a link to an old post I made on Vetric showing
my solution that has worked very well for me.
Two pieces of 3/4" ply with "tuning rods" underneath.
Since I "tuned" the table, it has been ROCK solid
and I have not had to retune ;)
This was a cheap & easy fix for me!!
http://www.vectric.com/forum/viewtopic.php?f=3&t=8090
Jim

Post Reply