Trouble with touch plate
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 227
- Joined: Mon Aug 13, 2012 7:16 pm
Trouble with touch plate
I recently purchased the touch plate along with the Pro hd machine. I tried to install the plate in next waves program, but the last step ( go figure) is to add the touch plate and say "ok". This doesnt exist on my screen! I have checked to see if i have the latest firmware and it says i do. HELP!
"I'm not smart, I just remain on problems longer"
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Re: Trouble with touch plate
Hi
Thr Shark control panel software will not display the touch plate button until you enter the regeristation code you receive from NWA. There is no trial period.
DickL
Thr Shark control panel software will not display the touch plate button until you enter the regeristation code you receive from NWA. There is no trial period.
DickL
Re: Trouble with touch plate
Once you get the software to show the option, I'll warn you about a little bug I found. Normally I FAST jog to a position close to where I want to set the Z=0 at. I found when I leave JOG on FAST the routine doesn't lift the bit after touching down. Put JOG on Step and it works fine.
-
- Posts: 227
- Joined: Mon Aug 13, 2012 7:16 pm
Re: Trouble with touch plate
Thanks to all. Will try OT when I get home.
"I'm not smart, I just remain on problems longer"
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm