rotary attachment
Moderators: ddw, al wolford, sbk, Bob, Kayvon
rotary attachment
Hi all-
I have been away from the forum for quite some time.
Anything new with the status of the rotary attachment.
I did a search and found nothing
Thanks-
Jim
I have been away from the forum for quite some time.
Anything new with the status of the rotary attachment.
I did a search and found nothing
Thanks-
Jim
Re: rotary attachment
The 4th axis is in Beta now.
We are working to have a kit out after the 1st of the year.
We are working to have a kit out after the 1st of the year.
Re: rotary attachment
Tim discussed some of the new stuff, including the 4th axis at the 2012 IWF show in Atlanta - http://www.youtube.com/watch?v=PrW9ktXV ... tu.be&hd=1
Re: rotary attachment
Thanks-
Looking forward
Jim
Looking forward
Jim
Re: rotary attachment
I saw the protoytype 4th axis setup at IWF. Looks like it will be a challenge to insure a kit will work with all the different Shark models. If anyone can do it though Tim can. I'd love the kit to be simple to swap the router from vertical to horizontal and back though, and that may take completely re-thinking the router mount design. I could see a simply cylindrical spindle motor clamped into a square "box" that could key/slide into the Z lift either horizontal or vertical. The housing on the Bosch router looks like it would prevent such a box though.
Re: rotary attachment
at the IWF we had both HD and Shark with the mounts it would work on either unit.
Re: rotary attachment
So can we see photos?
What's the release date and price?
What's the release date and price?
Re: rotary attachment
I hope the rotary comes out soon!
Would be nice to have!
Would be nice to have!
Re: rotary attachment
will it come with any special softwareTim Owens wrote:at the IWF we had both HD and Shark with the mounts it would work on either unit.
Re: rotary attachment
It comes with an interface software but not a new drawing software. You would use aspire or vcarve for it.