Hey all,
I'm trying to do this valentines project ( I got from Tony who's really tried to help me out ) for my new wife ( I know it's late ) but when I load the Tap file I get an error about nestled comments on line 16 on all four files. Hopefully someone can point me in the right direction.
Thanks in advance
John
g-code error
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 39
- Joined: Mon Sep 06, 2010 11:05 am
g-code error
- Attachments
-
- emma_rough.tap
- (143.62 KiB) Downloaded 143 times
-
- emma_finish.tap
- (2.22 MiB) Downloaded 157 times
-
- emma_lettering.tap
- (64.01 KiB) Downloaded 139 times
shark pro, Aspire 4 , VCP 6.5 , cut 3d ,
Re: g-code error
John,
The nested comments are probably comming from your tool data base information you have typed into it. You will have to remove the Parenthesis' from the information you entered.
The two lines that are causing the problem need to read as followed, I edited in useing notepad. Added my corrected version as an attachment.
16 (1 = End Mill 0.25 inch )
17 (End Mill 0.25 inch )
Buc
The nested comments are probably comming from your tool data base information you have typed into it. You will have to remove the Parenthesis' from the information you entered.
The two lines that are causing the problem need to read as followed, I edited in useing notepad. Added my corrected version as an attachment.
16 (1 = End Mill 0.25 inch )
17 (End Mill 0.25 inch )
Buc
- Attachments
-
- emma_rough.tap
- Emma_Ruff.tap corrected
- (143.62 KiB) Downloaded 148 times
I have not failed. I've just found 10,000 ways that won't work.
Thomas A. Edison
The Only Easy Day Was Yesterday
Thomas A. Edison
The Only Easy Day Was Yesterday
-
- Posts: 39
- Joined: Mon Sep 06, 2010 11:05 am
Re: g-code error
Buc,
Thanks for the quick response, will give it a try this evening.
John
Thanks for the quick response, will give it a try this evening.
John
shark pro, Aspire 4 , VCP 6.5 , cut 3d ,