Hello! I'm a new member and cannot find any reference to making dovetails with the Shark. Can the Shark be programmed to cut dovetail joints - pins and tails?
Thanks very much in advance! Don
Dovetails?
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Dovetails?
You should search Vectric.com/forum, the software provider that came with your shark. I believe you will find joints that can be cut there and the discussion that follows.
Good luck AND WELCOME TO THE FORUM.
Good luck AND WELCOME TO THE FORUM.
Re: Dovetails?
Go to this website and check out the wood joints designed for cnc machining.
http://flexiblestream.org/Digital-Wood-Joints-001.php
Bob
http://flexiblestream.org/Digital-Wood-Joints-001.php
Bob
Last edited by Bob on Mon Nov 22, 2010 11:12 pm, edited 1 time in total.
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Dovetails?
Thanks very much for your advice and warm welcome! I look forward to learning more. Best regards, Don