Error code displayed when starting PhotoVcarve.
var=
unknown variable name specified
on line 46 of file
C:\Program Files \PhotoVcarve\PostP\CNCSHARK-USB-GCODE_inch.pp
var ARC_CENTRE_I_INC_POSITION=[I|A|I|1.4]
I have unistalled the entire PhotoVCarve program and reinstalled it twice. I'm using Win XP. I even tried Windows Vista on another machine. Same problem.
I check the forum for similar issues and read with interest the comments from Dave regarding same issue just different error line and OP system. No help.
The frustrating part is when I open the program files C:\Program Files\PhotoVcarve\PostP I see the update listed (cncshark-USB_inch.pp.). I tried rebooting the PC after install same error message and still not able to see the update.
I know there is something I am over looking. Can someone advise.
Thanks Chips
Another Post Processor issue
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Another Post Processor issue
Did you copy a new post processor file to the PostP directory? This is not normally done by the installation software.
Paul Fison
Tacoma, Washington
Paul Fison
Tacoma, Washington
Paul Fison
Tacoma, Washington, USA
(253) 925-0855
Tacoma, Washington, USA
(253) 925-0855
Re: Another Post Processor issue (update)
Update. Somehow the file was corruted in a third computer using Win Vista and copied it to a CD and loaded it from the CD. Now no more error message. I can see the CNCSHARK-USB-GCODE_inch.pp in the PostP directory and evereything works okay.
Thanks for the help.
Chips
Thanks for the help.
Chips