Some comments and observations about new software with virtual zero. First off Tim and the folks a Automation have done an awesome job on the software. That being said I have been using it for about three weeks now and I am impressed how my lettering and the depth of V-Carve consistency has been. You start out with a board that is off .038" from touch off point to point and the Lettering is within .001" the same with V-Carves you not can depend on your depths set. For those of you who are on the bubble about this software it is well worth in my humble opinion.
Rick
Control panel 2.0 and Virtual Zero Comments
Moderators: ddw, al wolford, sbk, Bob, Kayvon