This started off just as one of my wooden zippo covers, but I liked the picture
a lot so I went ahead an made a delrin embossing plate for leather out of it. This piece is 3/4 oz leather
and it stands out about 1/10" off the surface. size is 2 1/2"x 2 1/2".
The lighter cover is Bubinga wood. cheers!
Alien Zenomorph leather embossing plate and lighter
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Alien Zenomorph leather embossing plate and lighter
"Out of my mind.....back in 5 minutes"
Rockler 60th Anniversary CNC Shark
w/digital probe, and 4th axis attachment.
ULS M300 Laser Engraver 50 Watt
Aspire and Corel Draw
NextEngine 2020i 3D scanner
Rockler 60th Anniversary CNC Shark
w/digital probe, and 4th axis attachment.
ULS M300 Laser Engraver 50 Watt
Aspire and Corel Draw
NextEngine 2020i 3D scanner
Re: Alien Zenomorph leather embossing plate and lighter
A special thanks to Grey Drakkon on the leatherworker.net board for his suggestion that I make the alien facehugger.
I think it turned out good and I think it will look good embossed next to the alien xenomorph.
Both are roughly 2.75" square. Engraved on delrin plastic as an embossing plate.
Cheers!
-Nick
I think it turned out good and I think it will look good embossed next to the alien xenomorph.
Both are roughly 2.75" square. Engraved on delrin plastic as an embossing plate.
Cheers!
-Nick
"Out of my mind.....back in 5 minutes"
Rockler 60th Anniversary CNC Shark
w/digital probe, and 4th axis attachment.
ULS M300 Laser Engraver 50 Watt
Aspire and Corel Draw
NextEngine 2020i 3D scanner
Rockler 60th Anniversary CNC Shark
w/digital probe, and 4th axis attachment.
ULS M300 Laser Engraver 50 Watt
Aspire and Corel Draw
NextEngine 2020i 3D scanner