I have built a small table using oak flooring as its surface. However, now that the table is built, I need someone to make me a small centerpiece for it (for a fee, of course). The centerpiece would be cut from a 1x6 or 1x8 piece of oak. The dimensions are 5-3/8 x 5-3/8 x 3/4 (nominal board thickness). I would like to have a large cursive capital E routed into the centerpiece. I can provide a drawing of the piece, and after routing, I would like to receive the part unfinished.
If anyone is interested in making this simple piece, please contact me through e-mail at jce1225@gmail.com. Thanks for your consideration.
Make me a small piece with your Shark?
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 584
- Joined: Sun Jan 15, 2012 6:46 pm
- Location: North Little Rock, Arkansas
Re: Make me a small piece with your Shark?
Still needing this done?
Being retired is hard work. Spending way too much time in the shop these days. (And loving it).
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
-
- Posts: 17
- Joined: Mon Nov 18, 2013 9:31 am
- Location: Brighton, CO
- Contact:
Re: Make me a small piece with your Shark?
Hi Keith,
I'm currently working with him. Turns out he lives fairly close to me. And thanks to Bob H. for the referral!
I'm currently working with him. Turns out he lives fairly close to me. And thanks to Bob H. for the referral!