Started making Christmas ornaments with the Shark.
Made a variety of 10 different ornaments.
Each made from 3.5 X 3.5 X .25 inch Poplar wood.
Used a 1/16 end mill and 60 Degree V bit from Whiteside Router Bits.
Being so small with soft wood, there was some tear out (not much), but what the heck.
Here is a sample of an inlay piece.
Mary Christmas!!!!
Christmas Ornaments
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Christmas Ornaments
Good job, Bill. It looks nice.
Re: Christmas Ornaments
Some more I made from the same size of wood but without inlay.