HD4 Failures during 3D Finish
Moderators: ddw, al wolford, sbk, Bob, Kayvon
HD4 Failures during 3D Finish
Any ideas if the ignored lines are connected to the problem? What causes lines to be ignored by the pendant/controller? I've noticed that all good runs have only one ignored line.
Re: HD4 Failures during 3D Finish
Try reading this topic and see if it might be similar to your problem. There is a clear explanation from Vectric for what caused it, and a solution.
http://forum.vectric.com/viewtopic.php?f=2&t=27479
Bob
http://forum.vectric.com/viewtopic.php?f=2&t=27479
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: HD4 Failures during 3D Finish
I use a zero plane should it be set at the depth of the dish (0.04in) instead of 0.00?
The ignored lines in the .tap file still worry me.