CNC Shark Forum

Hello everyone,

I'm new here in this fantastic community. I have a question for my little project, I know this question is vulgar but I don't have much experience! This is my first project, I'm learning on the internet.

Can I use this home switch brackets for my CNC Shark machines if the mounting holes align with the spacing in the aluminum rails and that laser able to cutting plastic abs?

Please let me know what all of you think.  I will post a picture of my project soon.

Thanks in advance.

The problem isn't mounting the switches, it's that the Shark control box doesn't have a way to use them. If you're using an alternative control method that supports switches it's a possibility.

If the standard setup supported switches, many of us would have added them by now. It's perhaps the most lacking feature of these great machines.