Shark HD ProPlus Virtual Zero problem
Posted: Wed Oct 04, 2017 7:27 pm
Hi All
For the past few weeks I have been happily carving on my shark using virtual zero with no problems at all..... Last evening when I went to use the vz it tried to burry the bit in the table, thinking I made a mistake I reset everything and tried again this time it went up and to the left topping out the z axis. I reset and carved the remaining files without vz with no problems. Stumped........ I checked my control panel and I have 2.1 build 25f....according to the "help" tab when I checked the version on there was older than the one I have. I have just reformatted the sd card in hopes this helps and I'll check in the morning. Anyone else have this issue or any idea???? Is there a version 3.0 I see it on the web from next wave but not sure its for this machine...
Bob
For the past few weeks I have been happily carving on my shark using virtual zero with no problems at all..... Last evening when I went to use the vz it tried to burry the bit in the table, thinking I made a mistake I reset everything and tried again this time it went up and to the left topping out the z axis. I reset and carved the remaining files without vz with no problems. Stumped........ I checked my control panel and I have 2.1 build 25f....according to the "help" tab when I checked the version on there was older than the one I have. I have just reformatted the sd card in hopes this helps and I'll check in the morning. Anyone else have this issue or any idea???? Is there a version 3.0 I see it on the web from next wave but not sure its for this machine...
Bob