Pockets the wrong size
Posted: Tue Nov 14, 2017 6:33 pm
Cutting out a box with tabs, holes & lock tabs. Problem is that all of the tab and lock holes are too small when machined. Instead of the lock holes being about .5" square, they are .25" square. Tab holes are also only 1/4" wide and about 1 3/4" long (should be just over 2")
I added dog bones so the tabs would fit, picked a pocket tool path cutting on the inside, added a .07" offset, wanted to makee the holes just a smidgen wider and longer so the tabs would fit.
What did I do incorrectly?
File attached
I added dog bones so the tabs would fit, picked a pocket tool path cutting on the inside, added a .07" offset, wanted to makee the holes just a smidgen wider and longer so the tabs would fit.
What did I do incorrectly?
File attached