Re: How does PAUSE work
Posted: Fri Jan 26, 2018 1:11 pm
Oh...and we also talked about using GCodeShim, which I posted about a while back at:
http://www.cncsharktalk.com/viewtopic.p ... +gcodeshim
If Roger and I decide it's worthwhile, I'm considering adding a command to scale an axis by percent/decimal fraction kind of thing. This can sometimes be helpful when the finished dimensions are just a little out of whack, and it's easier to just make the part a little longer. Honestly, I suspect it will be a nightmare, since the arc radii will be weird/wrong. But hey, I'll try anything (in hacking GCode) once!
Cheers!
Thom
http://www.cncsharktalk.com/viewtopic.p ... +gcodeshim
If Roger and I decide it's worthwhile, I'm considering adding a command to scale an axis by percent/decimal fraction kind of thing. This can sometimes be helpful when the finished dimensions are just a little out of whack, and it's easier to just make the part a little longer. Honestly, I suspect it will be a nightmare, since the arc radii will be weird/wrong. But hey, I'll try anything (in hacking GCode) once!
Cheers!
Thom