HD4 lost power.......reset button?? Disregard, found the fu

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
Wayney
Posts: 11
Joined: Tue Jan 30, 2018 7:48 pm

HD4 lost power.......reset button?? Disregard, found the fu

Post by Wayney »

I am into week for of running my new HD4 fairly successfully. Today I took to much off of a pass and the machine lost all power. I see no external reset button and after removing the case I see nothing visible there either. Looking for a little help / direction on this. I don't have access to an electrician till Monday and had big plans for this weekend yet.

I found the fuse.

Thanks in advance

SteveM
Posts: 168
Joined: Thu Sep 08, 2016 1:29 pm
Location: Franklin, Wisconsin

Re: HD4 lost power.......reset button?? Disregard, found th

Post by SteveM »

There should be a extra fuse inside the fuse holder! Did you try replacing it and start up the machine again?
It's not a expensive fuse. I believe you can get them at almost any hardware store.

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: HD4 lost power.......reset button?? Disregard, found th

Post by tonydude »

You should only go deep as half your bit size. example If you use a 1/4 end mill, the depth of cut should be 1/8

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply