Spoil board

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Spoil board

Postby Jim N » Mon Feb 19, 2018 11:44 am

Just a tip you may even know. I used dollar store foam board with double stick tape to cut out a 3.65" outside by 3.0 " inside ring out of 1/4" cast acrylic. No tabs and clean cut and didn't have to cut into my real spoil board. The acrylic was scrap from the dust shoe I made (but didn't use on this project) :roll:
Jim N
Posts: 92
Joined: Fri Jul 30, 2010 3:45 pm

Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 2 guests