Page 2 of 2
Re: Shark HD4 stuck at front 6" of machine
Posted: Tue May 15, 2018 7:10 am
by Janettx
Update, it is now fixed. The problem after taking the bed and gantry off (which would have been unnecessary) I noticed the back bearing looked different on one side than the other and one would not go past the plastic frame underneath. After looking at the good bearing I seen that the set screw was too loose and the bearing could rotate. It had rotated upside down so that the grove that enabled the bearing to pass over that plastic part was turned up. So I turned the bearing to the correct position and it glides like it use to. Thanks for your consideration and help
Re: Shark HD4 stuck at front 6" of machine
Posted: Tue May 15, 2018 4:54 pm
by sharkcutup
Glad to hear you have solved the problem. You now have your entire carving table back.
Awesome!!!
We here on this forum are always ready to help!
Sharkcutup
Re: Shark HD4 stuck at front 6" of machine
Posted: Tue May 15, 2018 4:56 pm
by Rando
Wow...that's a very unusual failure pattern. Thanks for letting us know what the root cause and solution was! No doubt it will help someone in the future. In addition to the motor coupling nuts, it sounds like those set screws should be added to the routine maintenance checklist. I've checked mine before and they were always tight, but clearly problems can happen when they're not. Thanks again for illuminating
a previously unheard-of failure mode, JanetTx.