shark hd4 problem
Posted: Sat May 26, 2018 2:14 am
Hi,
I purchased cnc machine in march barely use it, have baby on my hands.
first time it cut perfectly, i did three simple projects.
but the last time when i tried to cut, it cut my board through, right in the middle, but the rest of the project it didnt cut at all.
today i tried again. i bought dust boot, thought maybe its gonna help.
but somehow, after i set up virtual zero, and start router it cut three holes, and then it started drill in the air above the board about 1/2 inch higher.
whats the issue it could be?
Please help.
I didn't find the right solution from the Internet.
References:-
http://www.cncsharktalk.com/viewtopic.php?f=2&t=5631
Thanks
I purchased cnc machine in march barely use it, have baby on my hands.
first time it cut perfectly, i did three simple projects.
but the last time when i tried to cut, it cut my board through, right in the middle, but the rest of the project it didnt cut at all.
today i tried again. i bought dust boot, thought maybe its gonna help.
but somehow, after i set up virtual zero, and start router it cut three holes, and then it started drill in the air above the board about 1/2 inch higher.
whats the issue it could be?
Please help.
I didn't find the right solution from the Internet.
References:-
http://www.cncsharktalk.com/viewtopic.php?f=2&t=5631
Thanks