Page 1 of 1

Repeated parts processing

Posted: Mon Aug 06, 2018 1:29 pm
by Sparkie113
When I run a program but want to make a second copy the Shark seems to need to be Shut down each time.
The jog and other functions are grayed out and will not allow access to them until I exit the program and we start the shark software. Doing this I need to zero out the unit each time.
What am I doing wrong? Any suggestions?

Rich :?:

Re: Repeated parts processing

Posted: Fri Aug 10, 2018 7:46 am
by bill z
Sparkie113,

This happens from time to time on my older HD Pro when the USB cable from my laptop to the controller is bumped. Usually by me messing while cuts are being made.
If your machine relies on an external computer, like mine does, then make sure all electronics are grounded to eachother and all connections are solid and clean.

Just a suggetion from one that has seen this in recent past.