Hello Everyone ~
Recently I saw a post of a Shark Pro Plus where the table was doubled in length ( Y Axis ). They had actualy double the rails and the Y Axis screw, and then had placed a additional table to complete the project. Does anyone know where I might find that post here again?
Thanks
Dave L.
Cincinnati, Ohio
Extending Table Length
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Extending Table Length
Here's 2 good posts - http://www.cncsharktalk.com/viewtopic.php?f=9&t=498 and http://www.cncsharktalk.com/viewtopic.php?f=2&t=228
You'll need to contact Tim at Next Wave Automation - towens@nextwaveautomation.com - to cost this and obtain the extended version.
You'll need to contact Tim at Next Wave Automation - towens@nextwaveautomation.com - to cost this and obtain the extended version.
Re: Extending Table Length
Hello Dave, I'm one one the guys with a extended table. 25 x 60. What are some of your questions?
-
- Posts: 37
- Joined: Sat Sep 11, 2010 8:25 pm
Re: Extending Table Length
Hello Rapiddawg ~
I am using the Shark Pro Plus, and will need to have a longer (Y Axis) table in the near future. Since I already have the Shark Pro Plus, I would like to just order the extended rails, extended Y feed screw and such. I would use black corian to make my own extended bed, and order the aluminum T trac from Rockler. I would like to increase the bed length to 60". I am not sure if I would need beefier motors? The X and Z rack would remain the same dimensions.
Thanks for any help or ideas on this issue.
Dave L.
Cincinnati, Ohio
I am using the Shark Pro Plus, and will need to have a longer (Y Axis) table in the near future. Since I already have the Shark Pro Plus, I would like to just order the extended rails, extended Y feed screw and such. I would use black corian to make my own extended bed, and order the aluminum T trac from Rockler. I would like to increase the bed length to 60". I am not sure if I would need beefier motors? The X and Z rack would remain the same dimensions.
Thanks for any help or ideas on this issue.
Dave L.
Cincinnati, Ohio