Z-Axis adjustment

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Z-Axis adjustment

Postby boxerstoo » Sun Sep 09, 2018 12:36 am

My Black Diamond machine’s Z-Axis is not 90 degrees to my table.
This has never bothered me making lithographs.
Flattening my sacrificial board, I have pronounced lines on the X-Axis.
My gantry is as it should be, but my router bracket is out of alignment and I can see no way to be able to adjust it.
I have attached pictures thinking I am showing my problem. Are there any engineer type or Shark experts that have run into this and one up with a solution?
Thank you
Attachments
0DDF0FFB-5917-4664-ADE9-1E2ED90385E9.jpeg
1C7BFAFE-C86A-44A6-BA25-ACB65307F91D.jpeg
boxerstoo
 
Posts: 3
Joined: Mon Oct 07, 2013 9:53 pm
Location: Cordelia, CA

Re: Z-Axis adjustment

Postby sharkcutup » Mon Sep 10, 2018 9:01 am

I am not an engineer by no means. My experience is from an Aerospace and Industrial Quality Control background.

CNC machining/woodworking is a hobby and a means of not becoming a so-called 'couch potato' in my senior years.

First I would try unclamping the the router in its mounting clamp and moving it upward slightly then re-tighten mounting clamp and recheck alignment. The Router may be resting in mounting clamp with that slight out of alignment condition when resting on the slightly larger circumference of the router throwing it out of alignment. By moving the router upwards slightly you will be ensuring that the router mounting clamp is in full contact around the equal circumference of the router after the router mounting clamp is tightened.

Just a thought after reviewing the images you have posted!

Sharkcutup
Shark HD3 Pro Plus Extended Bed with Spindle
Facebook: Hogan's CNC Crafts
sharkcutup
 
Posts: 300
Joined: Tue Mar 08, 2016 5:23 pm

Re: Z-Axis adjustment

Postby jeb2cav » Mon Sep 10, 2018 10:44 am

I agree about moving the router 'up' a bit in the clamp so that only the flat/barrel side is used.

I would look at this though with a 'flat' rod in the chuck and a small square - against the table. From the pictures, it isn't clear to me if that wood held by the bit is actually 'flat' against the table.

Do you think you are out of alignment left to right / parallel with the gantry, or out of alignment perpendicular to the gantry?
jeb2cav
Site Admin
 
Posts: 1514
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky


Return to CNC Shark

Who is online

Users browsing this forum: Bob and 3 guests