Page 1 of 1

engraving large plastic laminate pieces

Posted: Thu Sep 20, 2018 4:18 pm
by TD On The Hill
Hi,

We're going to be making large 4" x 36" laminate pieces with names engraved on them to slide into signs, etc. You know what I'm talking about. It's like name badge material; white plastic with a thin layer of red on top. Any suggestions on best bits and speeds and feeds to use? I did a sample piece and it's a mess around the edges. Maybe my feed is too fast?

Re: engraving large plastic laminate pieces

Posted: Fri Sep 21, 2018 10:09 am
by Kayvon
Have you tried a V bit, maybe 90 degrees, with low RPM? I've spent enough time looking at the nametag to my cubicle that I'm convinced it was made similar to this.

Re: engraving large plastic laminate pieces

Posted: Fri Sep 21, 2018 6:45 pm
by jeb2cav
I've moved to bits from ToolsToday for plastic work. Depending on your machine, you may want to slow it down a bit as well. A 'wood bit' doesn't seem to cut as cleanly as it's not necessarily designed for this material.

Re: engraving large plastic laminate pieces

Posted: Sun Nov 04, 2018 6:56 am
by cconway
I have been doing this myself recently and after trial and error I found the best thing to use where the bits actually made for doing this type of work. I tried V bits and engraving bits, but they don't give the right look. Also best to use single line fonts. I got my plastic from a company called bfplasticsinc.com. They are great and I was able to order bits from them custom cut the the length I wanted which was 3" for about $16 a bit. The person to speak with there is Andy. I have included a picture of some of the bits and a few name tags I did as examples.