Rough cut does not touch material

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Rough cut does not touch material

Postby JPaden2200 » Sat Oct 27, 2018 12:08 pm

I downloaded the Christmas writh with bow project. It is compatible with my version of v-carve and Aspire. I recalculated the tool paths, checked the material parameters and set the job up using the virtual zero. However, when I run the rough cut tool path, the tool misses the material by about .25 inches. It will not rough cut the material. What would be the most likely reason? I did use test material, (Styrofoam) and the finish cut works, but not the rough cut. Thanks, Jack
JPaden2200
 
Posts: 9
Joined: Sat Jan 23, 2016 6:49 am

Re: Rough cut does not touch material

Postby tonydude » Sun Oct 28, 2018 6:09 am

Can you post the file, it would be easier to figure it out.

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 9.510, photo vcarve, cnc mako shark extended bed, control panel 2.1
tonydude
 
Posts: 1474
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY


Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 3 guests