Rough cut does not touch material
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 9
- Joined: Sat Jan 23, 2016 6:49 am
Rough cut does not touch material
I downloaded the Christmas writh with bow project. It is compatible with my version of v-carve and Aspire. I recalculated the tool paths, checked the material parameters and set the job up using the virtual zero. However, when I run the rough cut tool path, the tool misses the material by about .25 inches. It will not rough cut the material. What would be the most likely reason? I did use test material, (Styrofoam) and the finish cut works, but not the rough cut. Thanks, Jack
Re: Rough cut does not touch material
Can you post the file, it would be easier to figure it out.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.