Page 1 of 1

Rough cut does not touch material

Posted: Sat Oct 27, 2018 12:08 pm
by JPaden2200
I downloaded the Christmas writh with bow project. It is compatible with my version of v-carve and Aspire. I recalculated the tool paths, checked the material parameters and set the job up using the virtual zero. However, when I run the rough cut tool path, the tool misses the material by about .25 inches. It will not rough cut the material. What would be the most likely reason? I did use test material, (Styrofoam) and the finish cut works, but not the rough cut. Thanks, Jack

Re: Rough cut does not touch material

Posted: Sun Oct 28, 2018 6:09 am
by tonydude
Can you post the file, it would be easier to figure it out.

Tony