Page 1 of 1

Shark 2 Laser

Posted: Thu Nov 15, 2018 12:14 pm
by kferb
I recently purchased the Shark2 with laser. At first I could not get the laser to work and found out the Piranha processor was installed on my shark. After figuring that out I was able to install the correct processor and the laser works.

The problem I am finding is it takes about 3 to 4 passes for the laser burn to show up on any of my projects. I am not satisfied with the quality of the burn.

Am I expecting too much from the laser that came with my Shark or could I be doing something wrong?

ALSO is the laser that comes with the Shark the same laser that comes with the Piranha?

Could I have received the wrong laser? ANY suggestions would be greatly appreciated.

Thank you! Kevin