Uneven carve depth

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
kferb
Posts: 8
Joined: Tue Nov 13, 2018 10:35 am

Uneven carve depth

Post by kferb »

I cannot get an even carv depth on any project. Are there any adjustments that can be done to the bed or the router housing to fix this problem? OR does anyone have a fix solution?
Attachments
IMG_0746.jpg
IMG_0745.jpg
IMG_0754.jpg

SteveM
Posts: 168
Joined: Thu Sep 08, 2016 1:29 pm
Location: Franklin, Wisconsin

Re: Uneven carve depth

Post by SteveM »

On most machines, the bed isn't level. It would be a good idea to place a spoil board on top of the aluminum bed and then do a surface cut to make sure the cutter is level on every part of the table. Then try another cut. That should take care of the problem.

Post Reply