Older CNC Shark pro control panel V1.6 NON HD
I am trying to fine tune the x, y axis. Cutting hash lines every inch for 24". The problem is that its cutting a 1/16'' short over 24". I know there is a service mode but dont recall how to get into it. Can someone share it with me?
Calibration/admin mode shark pro control panel?
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: Calibration/admin mode shark pro control panel?
Tram your router. That is why you are leaving lines because the router or spindle isn't parallel to your spoilboard.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.