Page 1 of 1

Fusion 360, its CAM post processing and personal experience

Posted: Sun Dec 30, 2018 6:47 pm
by cjablonski
Just diving into fusion 360 due to the advantages it offers over most design programs and wondering if anyone would care to share thier experiences using it with a shark. Anyone?

Re: Fusion 360, its CAM post processing and personal experie

Posted: Sun Dec 30, 2018 7:25 pm
by Kayvon
I don't have any personal experience with it, but here's a thread about it:
http://www.cncsharktalk.com/viewtopic.p ... 47&start=0

And another about a post processor for it:
http://www.cncsharktalk.com/viewtopic.php?f=10&t=5196