HD 3 For Sale
Posted: Sun Jan 20, 2019 8:46 pm
Shark HD -3 $3250
This machine has less than 50 hours on it. I jumped the gun and purchased it as a second machine in anticipation of a large project that did not materialize. It has: water cooled spindle, touch plate, anti-static wire harness purchased from Thom Randolph in Washington. Since I had a machine already, when I purchased this one I did not purchase additional software. If you buy this machine you would need to purchase the software from Next Wave. V-Carve Desktop is approximately $379, and V Carve Pro is approximately $699. The machine is located in Lexington, SC. New, with the spindle and touch plate and wiring harness, it would sell for approximately $4600 while they have the HD4 on sale. If you desire additional information contact me at:
803-413-5946.
Barry Anderson
Thank You
This machine has less than 50 hours on it. I jumped the gun and purchased it as a second machine in anticipation of a large project that did not materialize. It has: water cooled spindle, touch plate, anti-static wire harness purchased from Thom Randolph in Washington. Since I had a machine already, when I purchased this one I did not purchase additional software. If you buy this machine you would need to purchase the software from Next Wave. V-Carve Desktop is approximately $379, and V Carve Pro is approximately $699. The machine is located in Lexington, SC. New, with the spindle and touch plate and wiring harness, it would sell for approximately $4600 while they have the HD4 on sale. If you desire additional information contact me at:
803-413-5946.
Barry Anderson
Thank You