Bit for 3D finish pass?
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Bit for 3D finish pass?
I have done several of the 3D clip art that came with the software and some from the internet. So far I have used an 1/8th inch ball nose end mill for my finish pass. What does everyone use? I also have a 2 flute 7.5 degree V-Groove engrave bit with a 1/16" tip that I am wanting to try. This one >>> https://www.freudtools.com/products/70-103
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips
Re: Bit for 3D finish pass?
You could use a 1/16" tapered ball nose or a 1/32".
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Re: Bit for 3D finish pass?
SteveM wrote:You could use a 1/16" tapered ball nose or a 1/32".
I just ordered a 1/16th ball nose also. Thanks!
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips