New Shark 2 axis cables not labeled

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

New Shark 2 axis cables not labeled

Postby Whisperwild » Mon May 06, 2019 12:18 am

I just got a Shark 2 and cannot find info or diagram showing the cable route. The Y cable from beneath the end of table is labeled... the Plastic sleeve wrapped X and Z cables are not... one DB connector sits at end of sleeve, and the other extends 6 inches beyond sleeve..with one RCA which I understand is ground. Can someone tell me which is which?
Whisperwild
 
Posts: 1
Joined: Sat Oct 06, 2018 12:10 am

Re: New Shark 2 axis cables not labeled

Postby OCEdesigns » Thu May 09, 2019 8:37 am

You can call Nextwave but you can also just plug them in and see which is which. It won't hurt anything.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 9.5
OCEdesigns
 
Posts: 71
Joined: Fri Jan 11, 2019 8:26 am

Re: New Shark 2 axis cables not labeled

Postby cbhelms » Thu May 09, 2019 2:29 pm

On my Shark, the cable with 2 wires with connectors; the short 1 goes to the Z connector and the other connector goes to the X connector. The Y wire is at the end of the table and it connects to the Y connector.
Hope this helps.

Colin Helms
cbhelms
 
Posts: 18
Joined: Mon Dec 26, 2011 8:35 pm
Location: Charlotte, NC


Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 1 guest