Milling open-cell foam
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Milling open-cell foam
I'd like to cut circles into cheap, soft foam to be used as mailing packaging. Has anyone tried that? What bits did you use?
-
- Posts: 105
- Joined: Fri Jan 11, 2019 8:26 am
Re: Milling open-cell foam
I just picked up some medium density open cell foam. I have not tried anything yet but was thinking the normal bit I use 1 and 2 flute upcut and just slow them down a little.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips
Maker of many chips