Pendant stalling

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Pendant stalling

Postby abiker » Fri Jun 07, 2019 8:09 pm

I am experiencing an issue with my pendant intermittently stalling on the file transfer. It does not complete the cut, and occasionally will Re-run to completion - or stalls in the same place.

Has anyone had a similar issue?

This is on a 2 year old hd4
abiker
 
Posts: 1
Joined: Fri Feb 03, 2017 7:15 am

Re: Pendant stalling

Postby tshelb619 » Sun Jun 09, 2019 1:04 pm

abiker,

I didn't have that particular problem but I did have issue with it blanking out and not displaying anything on the screen and would make beeping sounds. Next Wave told me it most likely lost the firmware and sent me files and instructions on how to do it I would have to sift through my emails but if you think you may want to try that then let me know and i will post those.

Tyler
tshelb619
 
Posts: 21
Joined: Fri Sep 01, 2017 11:50 am


Return to CNC Shark

Who is online

Users browsing this forum: No registered users and 5 guests