Vectric Laser Module

Anything and everything CNC-Shark-related

Moderators: ddw, sbk, al wolford

Post Reply
chada13
Posts: 4
Joined: Sat Feb 16, 2019 3:20 pm

Vectric Laser Module

Post by chada13 »

I have a CNC Shark HD4 Extended Bed. I just bought the Vectric Laser Module. I tried to burn a picture with my 7W laser. The code runs but the laser does not turn on. I have never had any issues before. I use the Next Wave CNC (inch)(*.tap) post processor. Everything appears to be set up correctly and run but the laser does not turn on. Is there a different post processor or something?
Thanks!

chada13
Posts: 4
Joined: Sat Feb 16, 2019 3:20 pm

Re: Vectric Laser Module

Post by chada13 »

I found the issue. It was the I - D - 10 - T Error (IDIOT).
One of the connections was slightly loose!

Post Reply