Page 1 of 1

Slight Pause On Y Axis Occassionally

Posted: Wed Sep 16, 2020 9:37 pm
by chada13
I've noticed a hiccup/bump in the movement of the Y axis. I have the Shark HD4 extended bed. It is a very small bump but it is noticeable. Really noticed it while running some laser files.

Once I noticed it, I put the pendant jog speed to slow and moved it along the Y axis. It was pretty consistent where the bump happened. Occasionally I would not notice the bump. It does happen in a couple different spots.

Any thoughts of what could be causing this? I try to keep the rails and screw gears lubed up.