Page 2 of 2

Re: Y & Z axis issues

Posted: Thu Feb 18, 2021 1:51 pm
by samuelburns
Here's the job setup too, I was only able to attach three files to my post
JobSetup.png

Re: Y & Z axis issues

Posted: Thu Feb 18, 2021 4:10 pm
by samuelburns
So my problem was that I was following the first getting started video that accompanied the machine where the guy uses the center offset and then when doing the toolpaths uses the bottom left corner.
I don't think the video ever circles back on that. Once I had the job starting on the bottom left instead of the center in the job details view all my problems went away.

Nextwave support people helped me fix that issue as I supplied them with the tap file and images from the software. My very first piece now cuts fine.