I have a 520
I have the 3hp water cooled spindle
I just bought the 7w laser
Both the spindle controller and the laser controller connect to the machine controller through the same 20-pin connector port on the controller.
I've looked for a 20-pin y-cable (2 into 1), and none that I've seen has 20 pins, they are 19/20 (with the 20th 'hole' being 'not there')
I want to be able to plug BOTH into the controller, and turn the power off to the one I am not using (NEVER have both powered on!) so I don't have to continuously un-plug and plug in cables.
https://www.amazon.com/GINTOOYUN-Extens ... 31&sr=8-11
The controller HAS 20 pins, so that 20th hole being blocked won't plug in, thus rendering it useless.
Does anyone make an actual 20/20 pin splitter cable?
Has anyone else attempted to have it so both laser & spindle are plugged in at the same time?
20-pin cable connections
Moderators: ddw, al wolford, sbk, Bob, Kayvon